lap timer bracket

The cockpit area is tiny so the only place for the timer display was on the tacho! the receiver sits on the rear subframe and the link wire just long enough to get to the front. The wires going into the plugs and connectors are pretty weany and look fragile, they were supplied without the sleaving and look quite exposed...taped that up with electrical tape...then I went round the bike taping wires and soon I realised if its wet while racing I might get a few electric problems...then i got the cable(zip) ties and tied down everything......as one does. Back to the bracket..problem solved, flat Alu plate about 0.9mm thick, drilled two fxixng holes, curved the edge to match the tacho dial....industrial velcro supplied by pzracing( but only managed to send me one half of velcro)...